Table of Contents
Advertisement
http://www.3jtech.com.tw
http://www.pnpipcameras.com
DWR User's Guide
3. Installation
3.1 Hardware Installation
Step 1: Place DWR to the best optimum transmission location. The best transmission location for
your DWR is usually at the geographic center of your wireless network, with line of sign
to all of your mobile stations.
Step 2: Connect DWR to your wired network. Connect the Ethernet WAN interface of DWR by
category 5 Ethernet cable to your switch/ hub/ xDSL modem or cable modem. A
straight-through Ethernet cable with appropriate cable length is needed.
Step 3: Supply DC power to DWR. Use only the AC/DC power adapter supplied with DWR; it
may occur damage by using a different type of power adapter.
3.2 Software Installation
There is no software drivers, patches or utilities installation needed, but only the configuration
settings. Please refer to this chapter which will instruct you how to configure and manage DWR
through the web user interface it supports. With this facility, you can easily access and monitor
through any one LAN port of DWR.
NOTE:
It will take about 55 seconds to complete the boot up sequence after powering on DWR.
3.2.1 Software Configuration
In DWR, it supports a simple user management function to configure the system. The DWR is
delivered with the following factory default parameters on the Ethernet LAN interfaces.
Default IP Address: 192.168.8.1
Default IP subnet mask: 255.255.255.0
WEB login User Name: cameras
WEB login Password: cameras
Copyright of 3JTech Co., Ltd. (also doing business as A3J Engineering Inc.)
10
Advertisement
Table of Contents
