3Jtech FWT Wifi AP Quick Setup Manual

3jtech fwt wifi ap usb x 4 wireless router

Download this manual

Ver 1.0.0.0

Quick Setup Guide for FWT Wifi AP_USB x 4

1. FWT Wifi AP_USB x 4 Packing List :

Before you start installing the FWT Wifi AP_USB x 4, please verify that the package contains

the following items:

One Set of FWT Wifi AP_USB x 4,

1x RJ-45 Network Cable, RJ-11 Phone Cable,

External 3G Antenna with 3M Antenna Cable,

3G USB Dongle (Optional),

1x Power Adapter,

CD with User's Manual, and this Quick Setup Guide

NOTE: Please notify your sales representative immediately if any items listed above is missing or damaged.

2. Hardware Connection Settings

1) Connect PC to LAN port of your FWT Wifi AP_USB x 4 using a RJ-45 cable.

2) Make sure the SIM card has inserted to the modem, and the modem is ready as well.

3) Connect XDSL/Cable to the WAN port of your FWT Wifi AP_USB x 4 using a RJ-45 cable if

needed.

4) Sequentially plug the external 3G USB dongle(s) into the USB connector on your

FWT Wifi AP_USB x 4 for the load balance with multiple 3G. (For example, if you own single

USB dongle, it must be connected to USB 1 port first; if you own two USB dongles, they

must be connected to USB 1 and USB 2 ports.)

NOTE: The SIM card should be inserted when the device is powered off.

5) Connect the power cable to the power connector of your FWT Wifi AP_USB x 4.

6) For using the Fixed Wireless Terminal (FWT) function, connect an analog phone to the

PHONE port of your FWT Wifi AP_USB x 4 using a RJ-11 cable.

Fig.1 The Connection of FWT Wifi AP_USB x 4

Since 1988

Page 1 Ver 1.0.0.0 Since 1988 Quick Setup Guide for FWT Wifi AP_USB x 4 1. FWT Wifi AP_USB x 4 Packing List : Before you start installing the FWT Wifi AP_USB x 4, please verify that the package contains the following items: One Set of FWT Wifi AP_USB x 4, 1x RJ-45 Network Cable, RJ-11 Phone Cable, External 3G Antenna with 3M Antenna Cable,...
Page 2 Ver 1.0.0.0 Since 1988 3. LED Description of the Rear Panel Color Status Yellow Lit when +12V DC power is on and working. POWER( Lit when receiving any new SMS(s). Yellow SMS( Off at any status except the incoming of new SMS(s). Lit when the WiFi function is enabled.
Page 3 Ver 1.0.0.0 Since 1988 4. Software Connection Settings Refer to the following sections to set up the FWT Wifi AP_USB x 4. Before the setup, please confirm that the LAN port of the AP has been connected with the PC via RJ-45: Set up 3G Settings for the FWT Wifi AP_USB x 4 Please connect your computer to the FWT Wifi AP_USB x 4’s LAN port.
Page 4: Restore Factory Default Settings
Ver 1.0.0.0 Since 1988 Also accordingly fill in the necessary parameters, including Access Point Name (APN), Dial Number, Username and Password for 3G Mode: 1~ 3 once the STEP 4 in Section 2 is configured. (Note: Make sure PIN code for SIM cards inserted into USB1/USB2/USB3 dongle has been disabled via your cell phone.) Click on Apply after completing the setup.