Step 4: Boot Up The Transmitter And Receiver - Optoma WHD200 Manual

Step 4: Boot up the Transmitter and
Receiver
(1) Place the two AAA batteries into the
remote control.
(2) After the power cord is plugged into the electrical outlet, the WHDI DEVICE will be turned on
automatically.
(3) If it is in Standby mode (Both POWER LED of transmitter and receiver are lit in red), press the
POWER button on both transmitter and receiver to turn on the transmitter and the receiver.
(4) If transmitter's HDMI out display is on (Transmitter POWER LED is lit in purple) and receiver
stay in Standby mode (Receiver POWER LED is lit in red), press the POWER button of receiver
ONLY to wake up and make connection between transmitter and the receiver for enable display
out on receiver side.
Note: User can press POWER button of transmitter to turn off both transmitter & receiver
simultaneously any time.
13