Powertrust Ups Option; Repackaging The Cabinet For Shipment - HP A1896A Installation Manual

4. Connect all user terminals to the server.
5. Connect all system peripherals to the server.
Attaching cables while the rails are extended fully forward will ensure
NOTE
sufficient slack for later maintenance.
6. Connect the cabinet power cord to the appropriate wall outlet.
If the cabinet being installed contains a PowerTrust UPS option, perform the
NOTE
steps under PowerTrust UPS Option.
7. Be sure all peripherals outside the cabinet are connected to wall outlets.
The cabinet/server system assembly is now ready for the power up process. Refer to
Chapter 4 for operating instructions.

PowerTrust UPS Option

Unpack the PowerTrust UPS and read all the installation information in the PowerTrust
System Guide part number 5961-8383. Once all the procedures listed in the UPS guide are
complete, perform the following steps to complete the UPS installation with the cabinet.
1. Position the UPS next to the cabinet on the floor.
2. Remove the jumper cord from the SPU to the PDU inside the cabinet.
3. Install one of the convenience cords (output cord) that came with the UPS into the AC
receptacle in the back of the SPU.
4. Place the other end of that cord into one of the Output outlets in the back of the UPS.
5. The other convenience cord is connected between the UPS and the system console.
6. Locate the appropriate input line cord for the UPS in the supplemental package
shipped with the UPS.
7. Plug the UPS into the appropriate wall outlet.
8. The system should now be ready for power up.

Repackaging the Cabinet for Shipment

Use the original packing material to repackage the cabinet for shipment. If the packing
material is not available, contact your local Hewlett-Packard Sales and Support Office
regarding shipment.
Chapter 3
Unpacking and Installation
PowerTrust UPS Option
3-7