Figure 6-2 Opening The Pivot Support Bracket - HP A1896A Installation Manual

System Servicing
Preparing the System for Servicing
3. Remove the three screws on each side of the support brackets which attach the bracket
to the cabinet frame (refer to callout (1) in Figure 6-2).
4. Grasp the system just below the front center of the support brackets and pull toward
you, extending the system fully forward on its rails.
5. Using a T15 TORX screwdriver, remove the three screws in the pivot support bracket
(refer to callout (2) in Figure 6-2).
6. Swing the pivot support bracket around to the right and secure it by pressing it against
the fixed support bracket. The pivot support bracket will click into place.

Figure 6-2 Opening the pivot support bracket.

7. To access the interior of the system for service, refer to the System Service Manual, part
number A3262-90011.
6-2 Chapter 6