Cisco ASR 1000 Series Configuration Manual page 82

Enabling WCCP Interoperability with NAT
Command or Action
Step 5
ip wccp service-number redirect in
Example:
Router(config-if)# ip wccp 61 redirect
in
Step 6 exit
Example:
Router(config-if)# exit
Step 7 interface type number
Example:
Router(config)# interface ethernet 2
Step 8 ip nat outside
Example:
Router(config-if)# ip nat outside
Step 9 ip wccp service-number redirect in
Example:
Router(config-if)# ip wccp 62 redirect
in
Step 10
exit
Example:
Router(config-if)# exit
Step 11 interface type number
Example:
Router(config)# interface ethernet 3
Step 12
ip nat inside
Example:
Router(config-if)# ip nat inside
IP Application Services Configuration Guide, Cisco IOS XE Release 3S (Cisco ASR 1000)
74
Purpose
Enables packet redirection on an inbound interface using WCCP.
Exits interface configuration mode and returns to global
configuration mode.
Specifies an interface on which to enable NAT and enters interface
configuration mode.
• This is the WAN-facing interface.
Designates that traffic originating from or destined for the interface
is subject to NAT and indicates that the interface is connected to
the outside network.
Enables packet redirection on an inbound interface using WCCP.
Exits interface configuration mode and returns to global
configuration mode.
Specifies an interface on which to enable NAT and enters interface
configuration mode.
• This is the WAAS-facing interface.
Designates that traffic originating from or destined for the interface
is subject to NAT and indicates that the interface is connected to
the inside network (the network subject to NAT translation).
Configuring WCCP