Cisco ASR 1000 Series Configuration Manual page 117

WCCPv2—IPv6 Support
SUMMARY STEPS
1. enable
2. configure terminal
3. ipv6 wccp [vrf vrf-name] {web-cache | service-number} [group-address multicast-address] [redirect-list
access-list] [group-list access-list] [password password]
4. ipv6 wccp check acl outbound
5. exit
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
Step 2 configure terminal
Example:
Device# configure terminal
Step 3 ipv6 wccp [vrf vrf-name] {web-cache | service-number}
[group-address multicast-address] [redirect-list
access-list] [group-list access-list] [password password]
Example:
Device(config)# ipv6 wccp web-cache
Step 4 ipv6 wccp check acl outbound
Example:
Device(config)# ipv6 wccp check acl outbound
Step 5
exit
Example:
Device(config)# exit
IP Application Services Configuration Guide, Cisco IOS XE Release 3S (Cisco ASR 1000)
Enabling the WCCP—IPv6 Outbound ACL Check
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Enables support for a Cisco content engine service group
or any content engine service group and configures a
redirect ACL list or group ACL.
Checks the access control list (ACL) for egress interfaces
for packets redirected by WCCP.
Exits global configuration.
109