Cisco ASR 1000 Series Configuration Manual page 73

Configuring WCCP
Command or Action
Example:
Device> enable
Step 2
configure terminal
Example:
Device# configure terminal
Step 3 ip wccp [vrf vrf-name] {web-cache | service-number}
[group-address multicast-address] [redirect-list
access-list] [group-list access-list] [password
password [0 | 7] ]
Example:
Device(config)# ip wccp web-cache password
password1
Step 4 interface type number
Example:
Device(config)# interface ethernet0/0
Step 5 ip wccp [vrf vrf-name] {web-cache | service-number}
redirect {in | out}
Example:
Device(config-if)# ip wccp web-cache redirect
in
Step 6 exit
Example:
Device(config-if)# exit
Step 7
interface type number
Example:
Device(config)# interface GigabitEthernet
0/2/0
Purpose
• Enter your password if prompted.
Enters global configuration mode.
Specifies a web-cache or dynamic service to enable on the
router, specifies a VRF-name to associate with the service
group, specifies the IP multicast address used by the service
group, specifies any access lists to use, specifies whether to use
MD5 authentication, and enables the WCCP service.
Targets an interface number for which the web cache service
will run, and enters interface configuration mode.
Enables packet redirection on an outbound or inbound interface
using WCCP.
• As indicated by the out and in keyword options,
redirection can be specified for outbound interfaces or
inbound interfaces.
Exits interface configuration mode.
Targets an interface number on which to exclude traffic for
redirection, and enters interface configuration mode.
IP Application Services Configuration Guide, Cisco IOS XE Release 3S (Cisco ASR 1000)
Configuring WCCP
65