Table of Contents
Advertisement
3. Mounting and Installation
3.1 Handling Precautions
This section explains the handling precautions for the C Controller module.
CAUTION
Use the C Controller module in an environment that meets
the general specifications shown in this manual.
Using this C Controller module in an environment outside
the range of the general specifications could result in an
electric shock, fire, erroneous operation, and damage to or
deterioration of the product.
While pressing the installation lever located at the bottom
of module, insert the module fixing tab into the fixing hole in
the base unit until it stops. Then, mount the module with the
fixing hole as a supporting point.
Incorrect loading of the module can cause a malfunction,
failure or drop.
When using the C Controller module in the environment of
frequent vibrations, tighten the module with screws.
Tighten the screws in the specified torque range.
Undertightening can cause a drop, short circuit or
malfunction.
Overtightening can cause a drop, short circuit or
malfunction due to damage to the screw or module.
Connect extension cables to the connectors of the base
unit and the extension module correctly.
After connection, check them for looseness.
Poor contact could cause an input or output failure.
Be sure to set the CompactFlash
the CompactFlash
Confirm it is completely set.
Poor contact may lead to malfunctions.
Completely turn off the externally supplied power used in
the system before mounting or removing the module.
Not doing so could result in damage to the product.
Do not directly touch the module's conductive parts.
Doing so could cause an operation failure or give damage
to the module.
TM
card by pressing it into
TM
card slot.
6
Advertisement
Table of Contents
