Carrier 42NQ012N Service Manual page 15

7-1-3. Name and Functions of Indications on Remote Controller
[Display]
All indications, except for the clock time indicator, are displayed by pressing the
1
Transmission mark
This transmission mark
remote controller transmits signals to the indoor
unit.
2
Mode indicator
Indicates the current operation mode.
(A : Auto,
: Cool,
3
Temperature indicator
Indicates the temperature setting.
ºC ºC
(17 to 30 )
4
FAN speed indicator
Indicates the selected fan speed.
AUTO or five fan speed levels
+
(LOW , LOW
HIGH ) can be shown.
Indicates AUTO when the operating mode is
either AUTO or
5
TIMER and clock time indicator
The time setting for timer operation or the clock
time is indicated.
The current time is always indicated except
during TIMER operation.
9
1
8
6
3
indicates when the
: Heat, : Dry, : Fan only)
+
, MED , MED
: Dry.
2 10
5
4
7
6
Hi-POWER indicator
Indicates when the Hi-POWER operation starts.
Press the Hi-POWER button to start and press it
again to stop the operation.
7
(PRESET) indicator
Flashes for 3 seconds when the PRESET button is
pressed during operation.
The mark is shown when holding down the
button for more than 3 seconds while the mark is
blinks.
Press another button to turn off the mark.
8
ECO indicator
Indicates when the ECO is in activated.
,
Press the ECO button to start and press it again
to stop operation.
9
A, B change indicator remote controller
When the remote controller switching function is
set, "B" appears in the remote controller display.
(When the remote controller setting is "A", there is
no indication at this position.)
10
Swing
Indicates when louver is swing.
Press swing button to start the swing operation
and press it again to stop the swing operation.
– –
14
FILE NO. SVM-10031
button.