Carrier 42NQ012N Service Manual page 13

5. ECO OPERATION
To automatically control room to save energy (except in DRY and FAN ONLY mode)
Press : Start and stop the operation.
Note: Cooling operation; the set temperature will increase automatically 1 degree/
hour for 2 hours (maximum 2 degrees increase).
6. TEMPORARY OPERATION
In case of the misplaced or discharged remote control
• Pressing the RESET button, the unit can start or stop
without using the remote control.
• Operation mode is set on AUTOMATIC
operation, preset temperature is 24°C
and fan operation is automatic speed.
7. TIMER OPERATION
Setting the ON Timer
1
Press ON : Set the desired ON timer.
2
Press : Set the timer .
3 3
Press : Cancel the timer .
Daily timer allows the user to set both the ON & OFF timers and will be activated on a daily basis.
Setting Daily Timer
ON
1
Press : Set the ON timer.
2
Press OF F : Set the OFF timer .
· During the Daily timer is activation, both arrows
Note:
· Keep the remote control in accessible transmission to the indoor unit;
otherwise, the time lag of up to 15 minutes will occur.
· The setting will be saved for the next same operation.
8. PRESET OPERATION
Set your preferred operation for future use. The setting will be memorized by the
unit for future operation (except air flow direction).
1. Select your preferred operation.
2. Press and hold
displays.
3. Press : Operate the preset operation.
Press
Press
Press
3
Press
Press
4
mark flashing.
for 3 seconds to memorize the setting. The
− 12 −
Setting the OFF Timer
OF F : Set the desired OFF timer.
: Set the timer.
: Cancel the timer
.
button during the ( or )
( or ) are indicated.
P mark
FILE NO. SVM-10031