Network Setup; System Setup - A SYSTEMS AV500HD User Manual

Network Setup

Network Setup

System Setup

HDCP ON / OFF
1. Press "ENTER" or → to Format select and from
bottom menu select the format type. (Default: H.264)
2. Recording format selection:
● AVI
● Webcam: Data stream is H.264 format but emulating
RJ45 Webcam; use for connecting external PC.
● H.264
3. DHCP: Enable or disable DHCP.
The default IP address is 192.168.0.200
The default Subnet: 255.255.255.0
Manual IP setting is enabled when DHCP is turned on.
4. Manual IP Setup for LAN video streaming.
5. Adjust the audio fader for audio level (Default: 75%);
press speaker icon to mute the audio output.
Mute
●
1. Press "ENTER" and use the "SEL Knob" to turn
HDCP On and Off.
When HDCP is not turned on, HDCP encrypted video
sources will not be allowed to pass through PGM.
*NOTE1: During streaming and recording, PGM
content is HDCP encrypted and SDI output is disabled.
*NOTE2: When HDCP is already enabled and user
attempts to connect other HDCP devices into an HDMI
ports that was previously unoccupied, please turn
the HDCP function off and then on again to decode
the signal. Otherwise, it will be able to display in the
multiview screen. User must do this for all HDCP
devices, unless devices were connected to AV500HD
first and then turn on the HDCP function.
31
AV500HD
Active
●
English