Basic Setup; Power Supply; Ground Terminal; Connecting The Monitor - A SYSTEMS AV400HD User Manual

BASIC SETUP

Power Supply

Connect the included power cord to AC IN connector on rear panel before use. Be sure to
use the included power cord for AC connection.

Ground Terminal

Depending on the circumstances of a particular setup, you may experience a discomforting sensation, or perceive that
the surface feels gritty to the touch when you touch this device, video cameras connected to it, or the metal portions of
other objects, such as projectors. This is due to an infinitesimal electrical charge, which is absolutely harmless. However,
if you are concerned about this, connect the ground terminal with an external ground. When the unit is grounded, a slight
hum may occur, depending on the particulars of your installation. If you are unsure of the connection method, contact the
nearest Asystems Service Center, or an authorized Asystems distributor for detailed information.

Connecting the Monitor

To begin operate the AV400HD, a monitor must be connected that supports Interface
input to the connector shown below.
English
Interface
Interface 2 Interface 3
Interface
Interface
Interface 2 Interface 3
Interface
8
Interface 4
Interface
Interface 4
Interface