Table of Contents
Advertisement
CLEANING AND CARE
GREASE FILTERS
Filters should be cleaned at least once a month. Never
operate the fan or microwave oven without the filters in
place.
1. Pull the tab toward the front of the oven, down slightly
and remove the filter. Repeat for the other filter.
2. Soak the filters in a sink or dish pan filled with hot water
and detergent. DO NOT use ammonia or other alkali;
they will react with the filter material and darken it.
3. Agitate and scrub with a brush to remove embedded
dirt.
4. Rinse thoroughly and shake dry.
5. Replace by fitting the filter back into the opening.
Grease
Filter
Tab
FAN
The fan will automatically start when heat rises from the
cooking surface and when convection, high mix, low mix
or the broil settings are used. This protects the microwave
oven from excessive temperature rise. The fan will stay
on until the temperature decreases. It cannot be turned
off manually during this time.
For other uses, select either high or low speed.
PRECAUTIONS FOR PROPER USE:
1. DO NOT leave cooking surface unattended while
using high temperatures. Automatic fan may start and
provide excessive air to the surface units. This may
cause spattering or boilover.
2. Avoid burning food.
3. Keep grease filters clean.
LIGHT
1. To replace light bulbs, first disconnect power to the
microwave oven at the circuit breaker panel or by
unplugging.
2. To release cover remove the screw on the light cover.
(See illustration.)
3. Replace bulbs only with equivalent watt bulbs available
from an Authorized Servicer or parts distributor. Bulbs
are also available at most hardware stores or lighting
centers. DO NOT USE A BULB LARGER THAN 30
WATTS.
4. Close light cover and secure with screw removed in
step 2.
CAUTIONS: Light cover may become very hot. Do not
touch glass when light is on. Do not use light for long
time use such as a night light.
CHARCOAL FILTER
Charcoal Filter is used for Non-vented, recirculated
installation. The filter should be changed every 6 to 12
months depending on use.
1. Disconnect power to the oven at the circuit breaker
panel or by unplugging.
2. Remove 3 screws that secure louver.
3. Remove louver by gently moving louver and pull away
from unit.
4. Pull the louver away from the oven.
5. Slide Charcoal Filter into position on support tabs.
6. Push louver back into place and gently snap tabs into
place by hand (engaging both the bottom and top tabs)
and replace the 3 screws to secure louver.
E 28
Light bulbs
Light cover
Screw
Advertisement
Table of Contents
