1. Manuals
  2. Brands
  3. Smeg Manuals
  4. Microwave Oven
  5. OTR111SU
  6. Installation instructions manual

Smeg OTR111SU Installation Instructions Manual

Over the range convection microwave oven
Hide thumbs Also See for OTR111SU:
1
2
3
4
5
6
7
8
9
Table of Contents

Advertisement

Quick Links

Download this manual See also: Instruction Manual
Over the Range Convection Microwave Oven
Installation Instructions
Model: OTR111SU
TINSEB399WRRZ

Advertisement

Table of Contents
loading

Related Manuals for Smeg OTR111SU

Summary of Contents for Smeg OTR111SU

  • Page 1 Over the Range Convection Microwave Oven Installation Instructions Model: OTR111SU TINSEB399WRRZ...

  • Page 2: Wall Construction

    2. WALL CONSTRUCTION Please read all instructions thoroughly before install- ing the Microwave Oven/Hood System. Two people are recommended to install this product. This Microwave Oven/Hood should be mounted against and supported by a flat vertical wall. The wall must be flat If a new electrical outlet is required, its installation should for proper installation.

  • Page 3: Hood Exhaust Duct

    Use the values in parentheses for calculating air flow re- 2. Neither SMEG nor the dealer can accept any liability sistance equivalent, which should total less than 140 feet. for damage to the oven or personal injury resulting from failure to observe the correct electrical connection procedures.

  • Page 4: Preparation Of The Oven

    • 1-1/2” Wood Bit or Metal Hole Cutter (if metal tact your dealer or SMEG AUTHORIZED SERVICER. cabinet is used) 3. Place carton upside down as shown in Figure 6-1.
  • Page 5 6. Rest the oven on its side as shown in Figure 7. Place portion (C) of the carton underneath to protect the Fan cover bracket outercase from being damaged. 7. Remove the two screws which secure the mounting plate to the rear side of the oven. Remove the mount- ing plate.
  • Page 6 5. Replace the fan cover bracket. Make sure the 2. Lift the Hood Fan Unit carefully and slip wires out fan blades are visible through the rear openings of cavity. See Figure 14. in oven before proceeding. Attach the fan cover CAUTION: Do not pull or stretch hood fan wiring.

  • Page 7: Oven Installation

    5. Attach the Fan Cover Bracket to unit with the 4 Template) and put the Toggle Nuts onto the Toggle screws removed in step 1 above. See Figure 16. Bolts. Figure 18. The Hood Fan Unit is now rotated for vertical Refer to instructions in Wall Template.
  • Page 8 MOUNTING OVEN TO THE WALL 6. Tighten the two unit mounting screws located in the grease filter openings. See Figure 23. Two people are recommended to attach the Microwave Oven/Hood to the Mounting Plate. 1. Place cut portion of carton (B) on top surface of range. Protection of the range cooking surface is recommend- ed.
  • Page 9 CHECK LIST FOR INSTALLATION 1. Make sure the unit has been installed according to all of the Installation Instructions, the Top Template and Wall Template. 2. Remove all packing material from the oven. 3. Plug in the power cord. 4. Read the Instruction Manual. 5.

Table of Contents