Akai DR16 Operator's Manual page 4

Backup of multiple disks
The DR16 may use audio data spread over several disks for a single project. When such a project
is backed up, the DR16 will automatically access the appropriate disks that contain the necessary
audio data. However, if the same audio data is used for several projects, the same audio data will
be backed up in duplicate.
If the entire disk mode is selected and the project(s) use multiple disks, the message
will appear in the display. Press the STORE/ENT key to continue the backup operation or
press the ESCAPE key to abort.
NOTE: When ENTIRE MODE is selected for backup, it will backup one disk only. When the
backup is successfully finished, the other disks that contains the necessary audio data must also
be backed up separately, again in the ENTIRE DISK mode. Please note that It is not possible to
backup data from several disks onto a single tape.
Verifying backup data
The DR16 can verify the backup data.
1) Press the SUB-MENU key followed by the 1(DISK) key in the numeric keypad and then
select
2) Press the STORE/ENT key . The message
3) Select
message
4) Select
5) The message
Drive that is to be verified.
6) Select the SCSI ID number of the SCSI Tape Drive using the JOG/SHUTTLE control and
press the STORE/ENT key to start verifying.
Assuming the verify process is completed without any errors, the message
appear in the display momentarily, then it resumes the normal mode of operation.
If any error is detected, the message
on the display by rotating the JOG/SHUTTLE control.
with the JOG/SHUTTLE control then press the STORE/ENT key. The
will appear in the display.
with the JOG/SHUTTLE control and then press the STORE/ENT key.
will be displayed. This is the SCSI ID number of the SCSI Tape
DR16 V2.0 Addendum
will appear in the display.
will be displayed.
will
Page 3