Other Problems - Miele TCE 630 WP Operating Instructions Manual

Heat pump tumble dryer
Table of Contents

Advertisement

Other problems

Problem
The drying process
goes on too long or
even switches off*
There are humming
noises
Possible cause and remedy
The room in which the tumble dryer is located is too
warm.
 Ventilate the room thoroughly.
Detergent residues, hair and fine fluff can clog the
filters.
 Clean the fluff filters and the plinth filter.
 Remove any visible fluff behind the panel in the
heat exchanger cavity (see "Cleaning and care -
Plinth filter").
The cool air intake (bottom right grille) is blocked.
 Move any objects, such as a laundry basket, away
from the dryer.
The fluff filters and the plinth filter were wet when
replaced.
 The fluff filters and the plinth filter must be dry.
The laundry is too damp.
 Spin using a higher spin speed in the washing
machine.
The tumble dryer has been overloaded.
 Do not exceed the maximum load for the
programme selected.
Metallic components, e.g. zippers, have prevented
the dryer from registering the correct moisture level.
 Open the zippers next time.
 If the problem recurs, dry these items using the
Warm air timed drying programme.
* Before starting another programme:
 Switch the dryer off and then on again.
The compressor is operating.
These noises are quite normal and do not indicate a
fault.
Problem solving guide
49

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tx2070

Table of Contents