Table of Contents
Advertisement
5. Installing the Ink Cartridges
Filling with Ink for the First Time
Special procedures are required when installing ink cartridges for the first time. These are required only once,
when installing ink cartridges for the first time after shipment from the factory.
You first clean the print heads using cleaning fluid, then fill with the inks of the various colors. This operation
requires eight SOL INK cleaning cartridges.
Never under any circumstances use anything other than the specified type of ink or cleaning fluid.
Installing the Ink Cartridges
Be sure to follow the on-screen instruc-
tions for insertion and removal.
➢ Keep the labeled side face up.
➢ Insert and remove slowly, one at a time.
➢ Insert firmly, as far as it will go.
During cleaning, you insert and remove cartridges several times. The on-screen messages indicate which to
insert and remove, and when to insert and remove them.
Insert each color ink cartridge into the slot labeled with the matching color. The cleaning cartridges are not
differentiated by color.
CAUTION
CAUTION
WARNING
30
In this procedure, never switch on any power switch except as instructed.
Sudden movement of the media take-up system or the like may cause injury, or heat from the
dryer may cause burns.
Never insert your hand or fingers into the opening of the front cover.
The print heads move at high speed inside the cover. Contact may cause injury.
Never place ink, cleaning liquid, or discharged fluid in any of the following loca-
tions.
• Near open flame
• In a hot location, such as near a heater or on the machine's platen or dryer
• Near bleach, chemicals, explosives, or the like
Doing so may cause fire.
SET SOLCL-LIQUID
Same number
Advertisement
Table of Contents
