Basic; Advanced - TP-Link AC750 User Manual

CR2 AC750 Wireless Dual-Band Router

4.4.1 Basic

This page is used to configure the parameters for wireless LAN clients which may
connect to your Access Point. Here you may change wireless encryption settings as well
as wireless network parameters.
Disable Wireless LAN Interface: Check this box to to disable the router's wireless
features; uncheck to enable it.
Band: Select one mode from the following. The default is 2.4 GHz (B+G+N) mode.
Mode: Support AP, Client, WDS and AP+WDS mode.
Network Type: This type is only valid in client mode.
SSID: SSID (Service Set Identifier) is the unique name of the wireless network.
Channel Width: Select the channel width from the pull-down list.
ControlSideband: This relates to the channel number used for your wireless network. An
upper band represents higher channels and vice versa.
Channel Number: Indicates the channel setting for the router.
Broadcast SSID: Select "Enable" to enable the device's SSID to be visible by wireless
clients. The default is enabled.
WMM: It will enhance the data transfer performance of multimedia data when they're
being transferred over wireless network.
Data Rate: Sets the maximum wireless data rate that your network will operate on.
Associated Clients: You can see the MAC Address, MAC address, transmission and
reception packet counters for each associated wireless client.

4.4.2 Advanced

These settings are only for more technically advanced users who have a sufficient
knowledge about wireless LAN. These settings should not be changed unless you know
what effect the changes will have on your Access Point.
27