TP-Link AC750 User Manual page 18

Band: This filed determines the wireless mode which the router works on.
5GHz (A) - Select if all of your wireless clients are 802.11a.
5GHz (N) - Select if all of your wireless clients are 802.11n.
5GHz (A+N) - Select if you are using both 802.11a and 802.11n wireless clients.
5GHz (AC) - Select if all of your wireless clients are 802.11ac.
5GHz (N+AC) - Select if you are using both 802.11n and 802.11ac wireless clients.
5GHz (A+N+AC) - Select if you are using both 802.11a, 802.11n and 802.11ac
wireless clients.
Mode: Support AP, Client, WDS and AP+WDS mode.
Network Type: This type is only valid in client mode.
SSID: Service Set Identifier, it identifies your wireless network.
Channel Width: Select the channel width from the drop-down list.
ControlSideband: This relates to the channel number used for your wireless network. An
upper band represents higher channels and vice versa.
Channel Number: Indicates the channel setting for the router.
Enable Mac Clone: Enable or disable MAC clone option. (You can use the "Mac Clone"
button to copy the MAC address of the Ethernet Card installed by your ISP and replace
the WAN MAC address with this MAC address.)
Step 6 Wireless 5GSecurity Setup
Secure your wireless network by turning on the WPA or WEP security feature on the
router. This section you can set WEP and WPA-PSK security mode.
The following picture shows how to set the WEP security.
CR2 AC750 Wireless Dual-Band Router
16