Attaching Mounting Accessories - NEC MultiSync C431 User Manual

Attaching Mounting Accessories

The monitor is designed for use with the VESA mounting
system.
1. Attach Mounting Accessories
Be careful to avoid tipping the monitor when attaching
accessories.
VESA Mounting Interface (M6)
300 mm
Mounting accessories can be attached with the monitor in
the face down position. To avoid damaging the front face,
place the protective sheet on the table underneath the LCD
monitor. The protective sheet was wrapped around the LCD
monitor in the original packaging. Make sure there is nothing
on the table that can damage the monitor.
When using mounting accessories other than NEC compliant
and approved, they must comply with the VESA Flat Display
Mounting Interface Standard (FDMI).
NOTE: Prior to installation, be sure to place the monitor
on a fl at area with adequate space.
2. Using Wall Mount Adapter
If the mounting accessory interferes with ventilation hole, use
the included wall mount adaptors (Dia. 14 mm) and screws.
If the adaptor screws are too long, include a washer to
reduce the depth. Washer not included.
Wall mount adapter (Dia. 14 mm)
Unit
10-12 mm
Pictured mounting solutions may not be available in some
countries.
Mounting bracket
Washer
Wall mount
adapter screw
18 mm
3. Installing and removing the optional
table top stand
CAUTION: Installing and removing the stand must be done
by two or more people.
For installation follow the instructions included with the
stand or mounting equipment. Use only those devices
recommended by the manufacturer.
NOTE: ONLY use screws which are supplied with the
optional table top stand.
When installing, do not put your hands on the
monitor or apply force. The monitor may become
distorted.
When installing the LCD monitor stand, handle the unit with
care to avoid pinching your fi ngers.
NOTE: Use the ST-401. Please refer to the ST-401
user's manual for more detail.
Height adjustment
1. The lines on the stand pole are indicators of the height
adjustment. Please adjust the pipe to the lines.
C551 High/Low
C501
C431
Adjust the pipe to a line.
2. Please install the stand pole and the pipe with included
screws. Please screw the two screw holes at the pipe.
Pipe
NOTE: Installing the monitor at the wrong height can
cause tipping.
Please install your monitor at proper height.
English-7
Pipe
Stand pole
Stand pole