Disabling Message Logging - Cisco Catalyst 2360 Software Configuration Manual

Configuring System Message Logging
Table 22-2
Feature
Time stamps
Synchronous logging
Logging server
Syslog server IP address
Server facility
Server severity

Disabling Message Logging

Message logging is enabled by default. It must be enabled to send messages to any destination other than
the console. When enabled, log messages are sent to a logging process, which logs messages to
designated locations asynchronously to the processes that generated the messages.
Beginning in privileged EXEC mode, follow these steps to disable message logging. This procedure is
optional.
Command
Step 1 configure terminal
Step 2 no logging console
Step 3
end
Step 4 show running-config
or
show logging
Step 5 copy running-config startup-config
Disabling the logging process can slow down the switch because a process must wait until the messages
are written to the console before continuing. When the logging process is disabled, messages appear on
the console as soon as they are produced, often appearing in the middle of command output.
The logging synchronous global configuration command also affects the display of messages to the
console. When this command is enabled, messages appear only after you press Return. For more
information, see the
To re-enable message logging after it has been disabled, use the logging on global configuration
command.
Catalyst 2360 Switch Software Configuration Guide
22-4
Default System Message Logging Configuration (continued)
"Synchronizing Log Messages" section on page
Chapter 22
Default Setting
Disabled.
Disabled.
Disabled.
None configured.
Local7 (see Table 22-4 on page
Informational (and numerically lower levels; see
Table 22-3 on page
Purpose
Enter global configuration mode.
Disable message logging.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Configuring System Message Logging
22-13).
22-9).
22-6.
OL-19808-01