Replacing Batteries; Technical Specifications Pro-Ject Pre Box S2 Analogue; Service; Warranty - Pro-Ject Audio Systems Pre Box S2 Analogue Instructions For Use

Replacing batteries

Proceed as follows:
• Unlock and slide open the battery case cover
• Replace the battery.
Make sure the battery is the right way around!
• Close the battery case cover
Battery type: 1 x CR2032 / 3V or 1 x CR2025 / 3V
Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries at
the appropriate collection sites - usually located at supermarkets and drugstores.

Technical specifications Pro-Ject Pre Box S2 Analogue

Frequency response:
Noise floor:
THD+N:
Gain:
Pre-Outputs:
Line-level inputs:
Input impedance:
Fix Output:
Outboard power supply: 5V/1A DC, suitable for your country's mains supply
Replacement battery remote control: 1 x CR2032 / 3V or 1 x CR2025 / 3V
Dimensions W x H x D: 103 x 37 x 120 mm
Weight:

Service

Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further advice. Only if the problem cannot be resolved there, the unit should be
sent to the responsible distributor in your country.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or changes to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.

Copyright, trademarks

Pro-Ject Audio Systems is a registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
Copyright © 2017. All rights reserved.
4
© Pro-Ject Audio Systems · Pro-Ject Pre Box S2 Analogue · Revision 2017.9.01
20Hz - 40kHz (+0 – 0,5 dB)
105dB (A weighted)
0,0005%
8,5 dB – Out; -2dB - Fix Output
1 pair RCA/phono sockets
2 pair RCA/phono sockets, 1x jack socket 3.5mm
15 kohms
3-pole 3,5mm co-axial jack
405g without power supply
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.