Other Problems; Thermal Cut-Out - Miele G 7804 Operating Instructions Manual

Other problems

Thermal cut-out

This machine has a resettable heater
limiter which will switch off the elements
in the event of over-heating. This could
be caused for example, by large
articles covering the heating elements
or if the filters in the wash cabinet are
blocked.
If the fault code: F01 - F02 ( water was
not heated up in the wash cabinet and
the programme is taking too long),
proceed as follows:
^ Remove the cause of the fault.
^ Open the service panel.
^ Press the reset button on the heater
limiter located on the right-hand side
of the plinth.
If this switch trips again, contact the
Miele Service Department.
60