Miele G 7804 Operating Instructions Manual page 54

For laboratory glassware
Table of Contents

Advertisement

Problem solving guide
Problem
The Add salt indicator
light k flashes.
The neutralising agent
indicator light w
flashes.
The rinsing agent
indicator light H
flashes.
The liquid cleaning
agent indicator light
8 flashes.
A few minutes after the
start of a programme,
the p / 6 indicator
flashes and the
programme is
cancelled.
54
Possible cause
The salt reservoir has not
been replenished,
meaning that the water
softener could not be
reactivated.
The neutralising agent
container is empty.
The rinsing agent
reservoir is empty.
The liquid cleaning agent
container is empty.
Fault code: F..E:
There is a water inlet
fault.
Remedy
– Fill carefully with salt.
– Fill the container with
neutralising agent or
replace it with a new, full
container.
– Vent the DOS module
where necessary.
– Fill the reservoir with
rinsing agent.
– Fill the container with liquid
cleaning agent.
– Vent the DOS module
where necessary.
Before trying to rectify the
problem, you must:
– Turn the programme
selector to f (the fault
code goes out).
– Switch the dishwasher off
with the I-0 switch.
– Open the stopcock.
– Clean the water inlet filter.
– The water pressure at the
intake is too low. Ask a
plumber for advice.
Then:
– Switch the dishwasher on.
– Start the programme
again.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents