Related Manuals for V-TUF VacM
Summary of Contents for V-TUF VacM
- Page 1 M class certified vac VAC M INDUSTRIAL VACUUM CLEANER User Operating Manual English Operators Manual © V-TUF...
- Page 2 VacM Full Parts Diagram Vac M 110 POS. V-TUF CODE DESCRIPTION VTVS7513 Self Tipping Screw 5x30 ZN VTVS7492 Handle E.2 VTVS7475 Black Cover VTVS7512 Self Tipping Screw 5x25 TC ZN VTVS7448 Foam Filter 130x25x7mm VTVS7490 Plastic Grid L144mm VTVS2022 Red Light Sw itch 2P...
-
Page 3: General Information
INTRODUCTION Thank you for purchasing a product from the V-TUF Industrial Cleaning Equipment range. V-TUF is focused on research and development to make sure you are fully satisfied with your purchase. Please read this manual carefully and follow the instructions to ensure you get the best performance from this machine. -
Page 4: Dry Vacuuming
IMPORTANT INFORMATION Never use the machine if you are unsure, or become uncertain due to any faults of any kind, including those not mentioned in this manual. Technical Information Model VacM Capacity 21 Litres Working Voltage 110 & 240 Volts... -
Page 5: Poisoning Hazard
SAFETY PRECAUTIONS Caution: what to do 1. All power conduction parts must be protected against water. SHORT-CIRCUIT RISK. 2. All services or maintainence performed on the appliance must always be done with the plug disconnected from the power supply. 3. Operation with a residual current circuit breaker provides extra protection for the operator (I_n=30 mA). -
Page 6: Troubleshooting
TROUBLESHOOTING PROBLEM PROBABLE CAUSE PROBABLE SOLUTION The machine does not No current. Check main fuse, power start cord, plug and outlet. The machine suddenly Because of overheating, After the machine has stops the thermal protection cooled down, you can turns the turn the power on again Machine off (feature only and begin to use the... - Page 7 Possible uses for the vacuum cleaner The vacuum appliances to which these user instructions refer are suitable for professional use and, in particular, for the control of dusts with an exposure limit value as per the class rating of the Vacuum cleaner. This is stated on the side of the tank. M CLASS The collection of the following materials are forbidden: - Incandescent materials;...
-
Page 8: Descriptive Information
Maintenance, cleaning and repair Only perform the maintenance work described in this booklet on the equipment. In case of uncertainty, contact the dealer or an authorized service centre. Before performing any cleaning or maintenance operations upon the device, remove both the electrical and compressed air power supply cables. - Page 9 Store the vacuum in a safe place where it cannot be accessed by unauthorised personnel. MAINTENANCE: FILTER REMOVAL ATTENTION Be careful to not stir up dusts when performing cleaning operations, filter checks or filter replacements. Use a protective mask. Or a V-TUF filter cleaning box. P a g e...
- Page 10 Replacing the filter bag Undo the head clips and remove the head. Remove the used filter bag and close the inlet with the tag as shown below. Dispose of the bag in the correct manner. Fit the new filter bag, making sure that the bag’s membrane seal fits perfectly over the internal slot of the tank inlet and that the bag fits neatly around the edge of the tank internal.
- Page 11 11 | P a g e...
- Page 12 For more details contact us: UK Head Office: +44 (0) 1522 515767 V-TÜF Fenco House Allenby Industrial Estate Lincoln LN3 4NR United Kingdom E-mail: enquiries@v-tuf.com Web: www.v-tuf.com Follow us: 12 | P a g e...