Operating Instructions - Lifestand LSC User Manual

LSC

Operating Instructions

1. Adjusting your wheelchair
1.1 The footrest
Adjust the footrest so that the thigh is almost
parallel to the base of the cushion
It is more comfortable if the FRONT of the thigh
is slightly raised.
Do not raise it too far as it could cause excess
pressure on the buttocks.
1.2 The tibia supports
1.2.1 : Adjusting the height and the inclination
Adjusting the height: The tibia supports can be adjusted to different heights. This adjustment
can be made by unscrewing the bolt in the tibia supports. Ideally the greater part of the tibia
support should be approximately 4 cm below the kneecap.
Adjusting the inclination: The holes in the tibia supports are fixed to the footrest cheeks by 2
screws. With the eccentric nut in the oblong hole and depending on the position of the eccentric
nut, you can tilt the tibia supports (4 different positions).
Tiblia support sheath
Adjusting the height
Bolt
Eccentric nut
15 15
User's Manual.
Footrest cheek
Oblong hole