Transformer Taps - Electro-Voice EVID-S5.2XB Installation Manual

EVID Surface Mount S Series - X Models
1.
2.
3.
4.
5.
6.
7.
8.
9.
See also
•
3.4

Transformer taps

You can select the mode of operation (70 V/100 V/8 ohm) and power taps using the rotary
switch on the input panel.
Configuring the transformer settings
To configure the transformer settings, do the following:
1.
2017.08 | 01 | F.01U.345.358
Push the wire through the gland nut.
Wire the Euroblock connector (A).
A
C
Adjust the tap settings, if needed.
Mount the speaker, as shown in the installation section.
Plug the Euroblock connector into the speaker.
Insert the four screws into the weather cover (B).
Loosely tighten the four screws to keep the weather cover in place.
Tighten all four screws to secure the weather cover.
Ensure the weather cover is secure.
Adjust the wire length.
Tighten the gland nut (C).
Installing the speaker, page 7
Select the desired power tap by using the rotary switch on the input panel.
A
+
B
Installation manual
A
B
C
Electro-Voice