Advertisement
4. Handling
4.1 Precautions for handling
(1) The main body case and terminal block are made of resin, so do not drop them
or apply strong impacts.
(2) Do not remove the module PCB from the case. Doing so could lead to faults.
(3) Make sure that foreign matter, such as wire scraps, does not enter from the top
of the module during wiring. Remove any foreign matter that does enter.
(4) Tighten the module installation screws and terminal screws within the following
ranges.
Module installation screw (M4 screw)
Terminal block terminal screw (M3.5 screw)
Terminal block installation screw (M4 screw)
Screw position
Tightening torque range
78 to 118N cm
59 to 88N cm
78 to 118N cm
Advertisement
