Table of Contents
Advertisement
control
code
0x05
0x109F
(Clusterid：0x FE60)
5-8. HeartBeat Technique
In a security system, it is important that Zone devices report the conditions to the central security unit (the
CIE device). To meet this need, Netvox came up with a technique called "HeartBeat".
Right after Z308 enrolls to a security system, it sends a HeartBeat signal to the CIE device. Afterward, it will
send HeartBeat data every hour by default settings.
5-9. Battery
When the operating voltage is lower than 2.1V, the indicator will flash
report to the ZigBee network.
The related data:
Power configuration cluster (ID:0x0001)
Battery voltage attribute (ID:0x0020)
5-10. Restore to Factory Setting
To restore it to factory setting, please follow the steps:
Step1. Press and hold the Panic Button or 15 seconds.
Step2. Release the button after the indicator shows fast
Step3. After 10
6. Home Automation Clusters for Z308
A cluster is a set of related attributes and commands which are grouped together to provide a specific function. A
simple example of a cluster would be the On/Off cluster which defines how an on/off switch behaves. This table
lists the clusters which are supported by Z308.
1.End Point(s)：0x01:
2.Device ID：IAS Zone（0x0402）
3.EndPoint Cluster ID
Server side
Sequence
number
flashes, it will go into turn-off mode. The indicator will be Off.
red
Cluster ID for Z308
EP 0x01 (Device ID: IAS Zone(0x0402) )
Count
identifier
0x5F
Byte
flashes.
red
Client side
9
NodeID
RSSI
... NodeID
2byte
Signed
once. Z308 will send a low-power
red
RSSI
Advertisement
Table of Contents
