Rear Finisher Light Assembly - Subaru legacy 2003 Service Manual

19.Rear Finisher Light Assembly

A: REMOVAL
1. SEDAN
1) Disconnect ground cable from battery.
2) Open the trunk lid.
3) Remove cover (A).
4) Disconnect connector (B) from rear finisher light.
5) Remove ten nuts and then detach rear finisher
light from trunk lid.
( B )
( A )
2. WAGON
1) Disconnect ground cable from battery.
2) Remove rear gate trim (A). <Ref. to EI-44, RE-
MOVAL, Rear Gate Trim.>
3) Disconnect connector from rear finisher light.
4) Remove nuts (A) and then remove rear finisher
light from rear gate.
( A )
( A )
B: INSTALLATION
Install in the reverse order of removal.
REAR FINISHER LIGHT ASSEMBLY
( B )
LI-00095
( A )
LI-00096
LI-00097
LI-23
LIGHTING SYSTEM