Combination Switch (Light) - Subaru legacy 2003 Service Manual

10.Combination Switch (Light)

A: REMOVAL
1) Disconnect ground cable from battery.
2) Remove instrument panel lower cover. <Ref. to
EI-35, REMOVAL, Instrument Panel Assembly.>
3) Remove screws which secure upper column
cover to lower column cover.
4) Disconnect connector from combination switch.
5) Remove screws which secure switch and re-
move switch.
B: INSTALLATION
Install in the reverse order of removal.
COMBINATION SWITCH (LIGHT)
LI-00009
LI-00010
LI-11
C: INSPECTION
Measure combination switch resistance.
(A)
8 7
17 16
(B)
8 7
17 16
(A) LHD model and RHD model with rear fog light
(B) RHD model without rear fog light
1. LIGHTING SWITCH
LHD model and RHD model with rear fog light:
Switch position Terminal No.
OFF
Tail 14 and 16
Head 13, 14 and 16
RHD model without rear fog light:
Switch position Terminal No.
OFF
Tail 9 and 15
Head 9, 14 and 15
2. DIMMER AND PASSING SWITCH
LHD model and RHD model with rear fog light:
Switch position Terminal No.
Passing 7, 8 and 16
Low beam 16 and 17
High beam 7 and 16
RHD model without rear fog light:
Switch position Terminal No.
Passing 1, 2 and 9
Low beam 9 and 10
High beam
LIGHTING SYSTEM
6 5 4 3 2 1
1514131211 10 9
6 5 4 3 2 1
1514131211 10 9
LI-00184
Standard
— More than 1 MΩ
Less than 1 Ω
Less than 1 Ω
Standard
— More than 1 MΩ
Less than 1 Ω
Less than 1 Ω
Standard
Less than 1 Ω
Less than 1 Ω
Less than 1 Ω
Standard
Less than 1 Ω
Less than 1 Ω
Less than 1 Ω
2 and 9