Location/Content - Johnson LDM100 Instruction Manual

2162i-1_Manuals 8/21/17 1:56 PM Page 4
4. Location/Content of Warning Labels
4
Error Code Label
The LDM may return an error code during use, as
indicated by the display showing "ERR X," where
"X" represents a number from 1 to 6.
The error codes are as follows:
1. Laser Range – The measurement distance is
outside the range listed in the specifications.
2. Weak Signal – The reflected laser signal is too
weak, either due to high ambient lighting at the
target or poor target reflectivity.
3. Display Range – The measurement distance,
area or volume exceeds the number of units the
display is capable of showing.
4. Low Battery – The batteries need to be replaced.
5. Temperature – The tool is either above the
maximum or below the minimum safe operating
temperature range.
6. Ambient Light – The tool is being used in too
bright of an environment to operate properly.
QR Code: Use a smartphone to scan the QR code to
be taken directly to Johnson Level & Tool's
Operator's Manual Page.
©2017 Johnson Level & Tool