Selecting Installation Site - Daikin FAA71AUVEB Installation Manual

Points for explanation about operations
If the items with
it may cause injuries and/or material damages. Therefore, in addition to the general usage, it is nec-
essary to explain them to the customer and also to ask the customers to thoroughly read them.
Accordingly, it is necessary that you make a full explanation about the described contents and also
ask your customers to read the operation manual.
2-4 NOTE TO THE INSTALLER
Be sure to instruct customers how to properly operate the unit (especially cleaning filters, operating
different functions, and adjusting the temperature) by having them carry out operations by them-
selves while reading the manual literally.

3. SELECTING INSTALLATION SITE

Do not exert pressure on the resin parts when opening the unit or when moving it after opening.
(1) Select an installation site where the following conditions are fulfilled and that meets with your
customer's approval.
• In the upper space (including the back of the ceiling) of the indoor unit where there is no possible
dripping of water from the refrigerant pipe, drain pipe, water pipe, etc.
• Where optimum air distribution can be ensured.
• Where the wall is strong enough to bear the weight of the indoor unit.
• Where the wall is not significantly tilted.
• Where nothing blocks the air passage.
• Where sufficient clearance for installation and maintenance can be ensured.
(Refer to Fig. 1 and Fig. 2)
• Where condensate can be properly drained.
• Where pipe between indoor and outdoor units is possible within the allowable limit.
(Refer to the installation manual of the outdoor unit.)
• Where not exposed to combustible gases.
• Install the indoor unit no less than 2.5 m above the floor. Where unavoidably lower, take what measures
are necessary to keep hands out of the air inlet.
[ Space required for installation (mm) ]
≥ 50
English
WARNING and CAUTION marks in the operation manual, are not observed,
Fig. 1
≥ 50
Obstruction
≥ 2500 (from floor)
For installation
in high places.
Floor
≥ 120
Fig. 2
5