USCutter SC2 User Manual & Assembly Instructions page 27

ISSUE
Cut has dashes or looks perforated.
EXAMPLE
CAUSE
Damaged cutting strip (groove in
strip) or too much blade is exposed
(friction build up).
SOLUTION
Replace the cutting strip or
decrease the blade depth.
ISSUE
Blade is skipping turns and corners.
EXAMPLE
CAUSE
Part of the blade is dragging on its
side during turns.
SOLUTION
Clean the inside of the blade holder by
coating the blade with WD40 and moving
it in and out of the blade holder. Clean off
any debris that comes out. Replacement
blade holder may be needed.
425.481.3555
Common Cutting Issues
ISSUE
Cut line tapers and not cutting
towards the end.
EXAMPLE
CAUSE
Dull blade or blade holder isn't
secured properly in slot.
SOLUTION
Replace blade, check the
blade force, and secure the
blade holder.
ISSUE
Corners are not cutting correctly.
EXAMPLE
ROUNDED CORNERS
CAUSE
Offset setting is incorrect.
SOLUTION
Change the offset setting.
RAISE OFFSET
27
www.uscutter.com
CORNERS WITH FLAGS
LOWER OFFSET