Home Start-Up Page - Dranetz HDPQ Xplorer User Manual

Upon start-up, the Home page serves as the access point for major instrument control
Home start-up
page
functionalities, as described below:
Start Monitoring - You have the option to use Automatic Setup and proceed directly
with data monitoring or configure the instrument step-by-step using the Wizard Setup.
You can also load previously saved setups or previously saved data from memory.
Setup is a configuration of parameter thresholds that control the data recorded by
HDPQ Xplorer. See Chapter 4 Setup Monitoring.
Real-Time Data - Displays voltage and current measurements, along with other
calculated parameters in different modes. See Chapter 3 Real Time Data.
Recorded Data - Displays recorded data in either graphic or textual form, including
events and trends, along with mini-reports and voltage compliance (EN50160) reports.
See Chapter 6 View Event Data & Reports.
Setup Instrument - You may perform instrument configuration settings such as time
and date display preferences, language selection, communications options, firmware
update, etc. See Chapter 5 Instrument Settings.
After the instrument has been powered up and monitoring is turned ON (and
Home
monitoring page
subsequently if monitoring is DONE), the Home Monitoring page becomes the start-up
page. Note the Start Monitoring icon changes into Stop Monitoring when monitoring
status is on, and vice versa.
Home Monitoring page allows you to view monitoring status and setups as configured.
The taskbar located on top of the screen features shortcuts to common instrument
functions. Icons to access real time meters and to view recorded data/reports are found
at the bottom of screen. This is the home page from which all other functions launch
and eventually return back to using the Exit function key.
Shop for Data Logging products online at:
DataLoggerStore
www.
CH 1/ Getting Started
HDPQ-111b
1-25
1.877.766.5412
.ca