Ptz Settings; External Alarm Settings; Motion Detection Settings - EasyN H Series User Manual

5.5.12.PTZ settings

As shown above, set 1 as address code, PELCO-D as protocol,9600 as baudrate. The default
data bits is 8, stop bit is 1.Five kinds of check ,they are no ,churh check,dual
check,mark,space.

5.5.13.External alarm settings

It is used to set the external alarm device, two modes are optional: nomally open and
normally close.

5.5.14.Motion detection settings

Here you can set four motion detection areas and the sensitivity ( from 0 to 75)
We never stop trying!
21