Yardworks 060-3808-8 Operator's Manual page 13

model no. 060-3808-8 | contact us: 1-866-523-5218
CONNECTING THE POLE
Before using the edger, a one-time assembly is required. When removed from the box, the
three poles are connected by an electrical cord as shown below.
1. Remove packaging material from cord and discard.
2. Slide upper handle tube down into middle handle tube so that the holes line up. There
are two positions available for adjustment to your preferred height setting.
3. Ensure the power cable moves smoothly down into the middle handle tube while
assembling.
4. Fasten the upper and middle handle tubes together with the knob (1, below) and
curved head bolt (2). Note that when you first insert the bolt it may be necessary
to wiggle it carefully to get it pass the jacketed wire inside the tube.
5. Repeat this process to attach the middle handle tube to the lower handle tube.
6. CAUTION: NEVER use a sharp object to move jacketed wires out of the way.
! WARNING: If any parts are damaged or missing, do not
operate this product until the parts are replaced. Using
a product with damaged or missing parts could result in
serious personal injury .
! WARNING: Failure to lock handle tubes as directed above
could result in serious injury or death.
UPPER
HANDLE TUBE
KNOB (1)
MIDDLE
HANDLE TUBE
LOWER
BOLT (2)
HANDLE TUBE
13