Environmental Conditions
The IT7300 series power supply can only be used indoors or in low
condensation areas. The following table shows general environmental
requirements for this instrument.
Environmental conditions
Operating temperature
Operating humidity
Storage temperature
Altitude
Installation category
Pollution degree
Regulation tag
Waste electrical and electronic equipment (WEEE) directive
Make sure the vent hole is always unblocked.
NOTE
In order to ensure the accuracy of measurement, it is recommended to operate the
instrument half an hour after start-up.
Waste electrical and electronic equipment (WEEE) directive,
2002/96/EC
The product complies with tag requirements of the WEEE
directive (2002/96/EC). This tag indicates that the electronic
equipment cannot be disposed of as ordinary household
waste.
Copyright © Itech
Requirement
0°C~40°C
20%~80%( non condensing )
-10°C~70 °C
Operating up to 2,000 meters
II
Pollution degree 2
The CE tag shows that the product
complies with the provisions of all
relevant European laws (if the year is
shown, it indicates that the year when
the design is approved).
This instrument complies with the WEEE
directive
requirements. This attached product tag
shows
that
product
cannot
household waste.
This symbol indicates that no danger
will happen or toxic substances will not
leak or cause damage in normal use
within
the
service life of the product is 10 years.
The product can be used safely within
the environmental protection period;
otherwise, the product should be put
into the recycling system.
Electronics Co., Ltd.
IT7300 User's Manual
(2002/96/EC)
the
electrical/electronic
be
discarded
specified
period.
The
tag
in
iii
Need help?
Do you have a question about the IT7321 and is the answer not in the manual?
Questions and answers