Table of Contents
Advertisement
Important!
• All 12 batteries must be installed. The P12 will not operate with less than 12 batteries.
• When removing the batteries, be careful not to touch the contacts.
• Replace all batteries at the same time. Do not mix battery types or brands, or insert used and new
batteries together.
To install the batteries, unplug the battery pack from your flash unit, and follow these steps:
1.
Press both battery tray release buttons to release the battery tray, and remove it from the P12.
2.
With the battery tray lying flat, insert six batteries in the battery bays. Make sure that each battery is
installed in the proper orientation.
3.
Turn the battery tray over, and repeat step two for the remaining six batteries.
4.
Insert the battery tray into the pack by sliding the tray into the slot, and pressing it in until it clicks
into place.
Note: The battery tray can be inserted into the pack in either orientation—there is no up or down.
Turn on the P12 by pressing and holding the power button until the indicator lights illuminate.
Turn off the P12 by pressing and holding the power button until the indicators turn off again.
|
Installing Batteries
9
Advertisement
Table of Contents
