Bluetooth Mobile Phone - Kenwood DDX419BT Instruction Manual

Bluetooth® Bluetooth®
2
Select the device ( 1 ) you want to connect,
then touch [Connection] (
Paired Device List
Device Name 1
Device Name 2
OK
Device Name 3
Connection
Device Name 4
Device Name 5 Remove
3
Select the device ( 1 ) to connect, then
return to the <Paired Device List> (
BT Connection Settings
Device Name
ON OFF
Connected
ON OFF
Connect Ready
Select [ON] (to connect) or [OFF] (to disconnect).
: Mobile phone
: Audio device
4
Connect the selected device.
Paired Device List
Device Name 1
Device Name 2
Device Name 3 OK
Device Name 4 Connection
Device Name 5 Remove
24 ENGLISH
• The status is shown as follows:
<Connecting>: Connection is in progress.
2 ).
<Connected>: A connection has been established.
<Connect Ready>: A connection is ready to be
established.
<Disconnecting>: Disconnection is in progress.
<Disconnected>: No connection is established.
• When a Bluetooth mobile phone is connected, the
signal strength and battery level are displayed when
the information is acquired from the device.
To delete the registered device: Perform step 1,
2 ).
select the device you want to delete in step 2, then
touch [Remove].
• A confirmation message appears. Touch [Yes].

Bluetooth mobile phone

When a call comes in...
1
Device Name 1
Incoming Call
Touching the operation keys performs the following
actions:
[ ]
[ ]
• Call information is displayed if acquired.
• Phone operation is not available while the picture
from the connected camera is displayed.
2
Device Name 2
Name
1234XXXXXX
Answers a call.
Rejects a call.
• When receiving a call during navigation guidance,
the screen is switched automatically.
– To return to the navigation screen, touch [
During a call...
1 2
Device Name 1 Device Name 2
Name
Talking...
1234XXXXXX
NR LEVEL –
0
EC LEVEL –
0
–
MIC LEVEL 0
DTMF
Touching the operation keys performs the following
actions:
[ ]
Ends a call.
[ ]/ Switches between handsfree mode and
[ ] phone mode.
[DTMF] Enters DTMF (Dual Tone Multi
Frequency), then sends text using the
keypad.
NR LEVEL Adjusts the noise reduction level.
[–] / [+] (–5 to 5)
EC LEVEL Adjusts the echo volume level.
[–] / [+] (–5 to 5)
MIC LEVEL Adjusts the volume level of the
[–] / [+] microphone. (–10 to 10)
Perform the following actions on the monitor panel to
adjust the volume of the call or earpiece.
DDX419BT/DDX419BTM: Press the volume
buttons.
DDX4019BT: Turn the volume knob.
].
+
+
+
J K
/