Programming The Memory Feature; Linking And Unlinking The Remote Keyless Entry Key Fob To Memory; Memory Seat Buttons - Dodge Durango 2017 User Manual

The memory seat switch is located on the driver's door trim panel. The switch consists of
three buttons:
• The set (S) button, which is used to activate the memory save function.
• The memory position (1) and (2) buttons which are used to recall either of two
pre-programmed memory profiles.

Programming The Memory Feature

NOTE:
To create a new memory profile, perform the
following:
1. Cycle the vehicle's ignition to the ON/
RUN position (Do not start the engine).
2. Adjust all memory profile settings to
desired preferences (i.e., seat, side mir-
ror, power tilt and telescopic steering
column [if equipped], and radio station
presets).
3. Push and release the set (S) button on
the memory switch.
4. Within five seconds, push and release
either of the memory position buttons (1) or (2). The instrument cluster display will
show which memory position has been set.
NOTE:
• Memory profiles can be set without the vehicle in PARK, but the vehicle must be in
PARK to recall a memory profile.
• To set a memory profile to your key fob, refer to "Linking And Unlinking The Remote
Keyless Entry Key Fob To Memory" in this section.

Linking And Unlinking The Remote Keyless Entry Key Fob To Memory

Your key fobs can be programmed to recall one of two pre-programmed memory profiles
by pushing the unlock button on the key fob.
NOTE:
Before programming your key fobs you must select the "Memory Linked To FOB" feature
through the Uconnect system screen. Refer to "Uconnect Settings " in "Understanding
Your Instrument Panel" in the Owner's Manual on www.dodge.com/en/owners/manuals for
further information.
To program your key fobs, perform the following:
1. Cycle the vehicle's ignition to the OFF position.
2. Select a desired memory profile 1 or 2.
G E T T I N G S T A R T E D

Memory Seat Buttons

61