12-2.Remote Controller Master/Slave Setting - Fujitsu ARYG24LHTBP Technical Manual

12-2. Remote controller master/slave setting
1. Touch the [RC Master/Slave Setting] on the "Initial Setting" screen.
2. "RC Master/Slave Setting" screen is displayed. Select the [Master] or [Slave].
NOTES:
• Set only one Master remote controller. Units specified other than [Master] are set to [Slave] auto-
matically.
• Do not perform "RC Mater/Slave Setting" during setting or operating from the Master remote
controller.
Initial Setting
Page 3/ 3
RC Master/
Slave Setting
Previous
Back
Page
R.C. Master / Slave Setting
Master
Slave
Cancel OK
- 68 -