Replacing The Presser Foot - Brother 885-E35 Operation Manual

X Two lines of stitching are sewn parallel to
each other.
Note
• When using the twin needle, the stitches may become
bunched together, depending on the types of thread and
fabric that are used. If this occurs, increase the stitch
length. For details on adjusting the stitch length, refer to
"Adjusting the stitch length and width" (page 26).
CAUTION
• When changing the sewing direction, be
sure to raise the needle from the fabric, and
then raise the presser foot lever and turn the
fabric. Otherwise the needle may break or the
machine may be damaged.
• Do not try turning the fabric with the twin needle
left down in the fabric, otherwise the needle may
break or the machine may be damaged.

REPLACING THE PRESSER FOOT

CAUTION
• Always turn off the power before you change
the presser foot. If you leave the power on and
step on the foot controller, the machine will
start and you may be injured.
• Always use the correct presser foot for the stitch
pattern you have chosen. If you use the wrong
presser foot, the needle may strike the presser
foot and bend or break, and may cause injury.
• Only use presser feet that have been designed
to be used with this machine. Using other any
presser feet may cause an accident or injury.
Replacing the presser foot
Replace the presser foot as described below.
1
Raise the needle in the following way.
or
1 Turn the handwheel so
that the mark on the
wheel points up.
2 Press the Needle position
button (for the models
equipped with this button).
KNOWING YOUR SEWING MACHINE
2
If the sewing machine has been turned on,
turn it off.
CAUTION
• Before replacing the presser foot, be sure to
turn off the sewing machine, otherwise injuries
may occur if the foot controller or the start/
stop button is accidentally pressed and the
machine starts sewing.
3
Raise the presser foot lever.
4
Press the black button to release the presser
foot.
5
Place a different presser foot below the
presser foot holder so that the presser foot
pin is aligned with the shank in the holder.
Position the presser foot so the letter indicating
the presser foot type (J, A, etc.) is positioned to
be read.
Note
• The presser foot to be used with each stitch
appears in the LCD. To select a stitch, refer
to "Selecting a stitch" (page 25).
6
Slowly lower the presser foot lever so that the
pin snaps into the shank.
1 Presser foot lever
2 Shank
3 Pin
X The presser foot is attached.
1 Black button
1 Presser foot holder
2 Shank
3 Pin
23
1