Download  Print this page

Brother 885-E35 Operation Manual page 66

Hide thumbs

Advertisement

APPENDIX
8
Remove the bobbin case.
If threads remain in the bobbin case, remove
them.
1 Bobbin case
9
Use the cleaning brush or a vacuum cleaner
to remove any dust from the race and its
surrounding area.
1 Cleaning brush
2 Race
• If the fabric could be removed 
Continue to step
• If the fabric could not be removed 
Continue to step
10
Use the included disc-shaped screwdriver to
loosen the two screws on the needle plate.
Note
• Be careful not to drop the removed screws
in the machine.
1 1
Slightly lift up the needle plate, cut any
tangled threads, and then remove the needle
plate.
Remove the fabric and threads from the needle
plate.
64
16
.
10
.
If the fabric cannot be removed, even after
completing these steps, contact your nearest
authorized service center.
12
Remove any threads in the race and around
the feed dogs.
13
Turn the handwheel to raise the feed dogs.
14
Align the two screw holes in the needle
plate with the two holes at the needle plate
mounting base, and then fit the needle plate
onto the machine.
15
Lightly finger-tighten the screw on the
right side of the needle plate. Then, use the
discshaped screwdriver to firmly tighten the
screw on the left side. Finally, firmly tighten
the screw on the right side.
Turn the handwheel to check that the feed
dogs move smoothly and do not contact the
edges of the slots in the needle plate.
1 Correct position of feed dogs
2 Incorrect position of feed dogs
Note
• Be careful not to drop the removed screws
in the machine.
16
Insert the bobbin case by following step
"Cleaning the race" (page 61).
17
Attach the needle plate cover by following
8
9
steps
and
in "Cleaning the race" (page
61).
18
Check the condition of the needle, and then
install it.
• Refer to "Checking the needle" and
"Replacing the needle" (page 21).
7
in

Hide quick links:

Advertisement

loading

  Related Manuals for Brother 885-E35