Section 5 Supported Services - ABB IEC 61850 Edition 2 Communication Protocol Manual

1MRK 511 393-UEN A
Section 5
670 series 2.2 IEC
Communication protocol manual
Supported services
IEC 61850-7-2 describes the services in the standard. IEC 61850-8-1 describes
how the services are applied in the communication. The conformance documents
contain the description of the supported services in the IED.
Services that are not mentioned in this chapter or in the conformance document are
not supported by the IED.
GOOSE simulation is supported according to IEC 61850 7-2.
If LD0.PHD.ST.Sim.stVal is set to true, the incoming GOOSE with test-bit in the
GOOSE header set is treated as a real GOOSE. The real GOOSE is discarded as
soon as a GOOSE with test-set is received. When LD0.LPHD.ST.Sim.stVal is set to
false, the real GOOSE is active again and GOOSE with test-bit set is discarded.
Data set
Define data sets by the SCD description.
Create data sets under LD0/LLN0.
For more information on data sets, see the PIXIT-related
documents.
Substitution
Substitution is supported for the respective DATA, according to IEC 61850-7-4,
that have the substitution attributes defined.
Setting group control block
There is only one setting group control block, which is located in LD0/LLN0
(Logical Device0/Logical Node 0).
Change or edit of some setting values as well as reading of setting values is
supported in IEC 61850. Note that change/edit of setting over IEC 61850 is only
supported when the IED is configured in Edition 2 mode.
In the IED a parameter regarding IEC 61850 settings has to be enabled to allow
writing/modifying settings from a IEC 61850 client. The status of output
REMSETEN in the function block ACTVGRP in the IED shows whether it is
possible or not to change settings over IEC 61850.
The Setting range is expressed in the minVal and maxVal data attributes (DAs) in
each setting data object (DO). When writing settings, a check will be done to
Section 5
Supported services
GUID-E08C91D7-A59B-478B-B39A-26E786591E2A v8
33