Iec 61850 Edition 1 / Edition 2 Mapping - ABB IEC 61850 Edition 2 Communication Protocol Manual

Relion 670 series

Hide thumbs Also See for IEC 61850 Edition 2:

Communication protocol manual (68 pages)

Table Of Contents

Table of Contents

1MRK 511 393-UEN A

1.5

670 series 2.2 IEC

Communication protocol manual

For example, select Main menu/Settings.

•

LHMI messages are shown in Courier font.

For example, to save the changes in non-volatile memory, select Yes and

press

•

Parameter names are shown in italics.

For example, the function can be enabled and disabled with the Operation

setting.

•

Each function block symbol shows the available input/output signal.

•

the character ^ in front of an input/output signal name indicates that the

signal name may be customized using the PCM600 software.

•

the character * after an input signal name indicates that the signal must

be connected to another function block in the application configuration

to achieve a valid application configuration.

•

Logic diagrams describe the signal logic inside the function block and are

bordered by dashed lines.

•

Signals in frames with a shaded area on their right hand side represent

setting parameter signals that are only settable via the PST, ECT or

LHMI.

•

If an internal signal path cannot be drawn with a continuous line, the

suffix -int is added to the signal name to indicate where the signal starts

and continues.

•

Signal paths that extend beyond the logic diagram and continue in

another diagram have the suffix "-cont."

Illustrations are used as an example and might show other products

than the one the manual describes. The example that is illustrated is

still valid.