Compatible Products; Drives And Option Modules; Controller Stations; Tools - ABB FSO-12 User Manual

16 Introduction to the manual

Compatible products

Check the compatibility of the earlier versions with your local ABB representative.
See also section FSO module version handling


Drives and option modules

• ACS880 series
• ACS880 primary control program: version 2.12 or later
• FENA-21 Ethernet adapter module: version 3.05 or later
• FPNO-21 PROFINET fieldbus adapter module: version 1.00 or later


Controller stations

For example the following controller stations are supported. Check the compatibility
of the controller station in its manual.
• ABB AC500-S Safety PLC. For more information, see AC500-S Safety User
Manual (3ADR025091M0207 [English])
• Siemens SIMATIC Fail-safe S7 PLC


Tools

• Drive composer pro PC tool: version 1.7 or later
Note: This manual applies to the Drive composer pro PC tool versions until 1.12. If
you use a later version, the menus and button names can differ from the ones used in
this manual. For more information, see the documentation of the tool.

Supported safety functions

This manual provides instructions for creating the following safety functions
(according to EN/IEC 61800-5-2) for the ACS880 drives:
• Safe torque off (STO) – standard feature in the ACS880 drives, see page
• Safe brake control (SBC), see page
• Safe stop 1 (SS1), see page
• Safely-limited speed (SLS), see page
• Variable Safely-limited speed (SLS), with PROFIsafe only, see page 124.
Additional safety functions (not specified in EN/IEC 61800-5-2):
• Safe stop emergency (SSE), see page
• Safe maximum speed (SMS), see page
• Prevention of unexpected start-up (POUS), see page 132.
Note: The FSO-12 module does not support an encoder in safety applications.
on page 39.
43
61
94
76
129
55