Winching; Hoisting - Snorkel AB60J Operator's Manual

Chapter 9 – Stowing and Transporting
7. Rotate the turntable slightly to the side so you can
see the front wheels.
8. Verify that the machine wheels, loading ramps, and
transport vehicle are aligned.
Danger
The aerial platform can tip over if it becomes unstable.
Death or serious injury will result from a tip-over ac-
cident. Set the drive range to low before driving up
or down a grade.
9. Place the drive range switch in the low position.
10. Drive the aerial platform onto the transport vehicle
in a straight line through the grade transitions with
minimal turning.
11. Rotate the turntable to align the booms between the
rear wheels.
12. When driving down the ramp, always back the ma-
chine with the platform on the downhill side only.

Winching

Use the following procedure to winch the aerial platform
onto the transport vehicle:
1. Locate the transport vehicle so the aerial platform
will not roll forward after it is loaded.
2. Remove any unnecessary tools, materials, or other
loose objects from the platform.
3. Drive the machine to the foot of the loading ramp
with the front wheels nearest the ramp. Make sure
the machine is centered with the ramps and that the
steering wheels are straight.
4. Fully retract the tip boom. Lower the main boom and
jib as much as possible making sure there is adequate
ground clearance between the platform and the
ramp.
5. Attach the winch to the tie-down lugs (refer to Figure
9.2) on the front of the chassis.
Tie-Down/Lifting Lugs
Figure 9.2 – Front Tie-Down/Lifting Lugs
54
6. At each drive wheel, remove the two bolts from the
disconnect plate (refer to Figure 9.3). Turn the plate
over so the nipple points inward. Reinstall the two
bolts.
Bolt
Figure 9.3 – Drive Wheel
7. Use the winch to position the aerial platform on the
transport vehicle.
Warning
The aerial platform is free to move when the drive
hubs are disabled. Death or serious injury can result.
Re-enable the drive hubs before operating the aerial
platform.
8. At each drive wheel, remove the two bolts and return
the plate to its original position as shown in Figure
9.3.
9. Start the engine and operate the drive control in for-
ward and reverse several times to engage the drive
hubs.

Hoisting

Use a four point sling arrangement attached to the lifting
lugs when hoisting the aerial platform. Machine damage
can occur if the sling is attached to the booms, turntable,
or platform.
Warning
The potential for an accident increases when the
aerial platform is lifted using improper equipment
and/or lifting techniques. Death or serious injury
could result from such accidents. Use proper equip-
ment and lifting techniques when lifting the aerial
platform.
Know the weight of the aerial platform and the capacity
of the lifting devices before hoisting.
Lifting devices include the hoist or crane, chains,

straps, cables, hooks, sheaves, shackles, slings, and
other hardware used to support the machine.
Disconnect
Plate
AB60J – 0181972