Emergency Stop; Emergency Power; Horn; Electrical Power Outlet - Snorkel AB60J Operator's Manual

Chapter 7 – Prestart Inspection

Emergency Stop

To test the emergency stop button from the upper con-
trols:
1. At the lower controls, start the engine and place the
control selector switch in the upper control position.
2. At the upper controls, push the emergency stop but-
ton (refer to Figure 7.19) inward to turn off electrical
power.
3. Verify that the engine shuts off and the upper control
functions do not operate.

Emergency Power

To test the emergency power system from the upper
controls:
1. Turn the battery disconnect switch on.
2. At the lower controls, pull the emergency stop button
outward and place the start switch in the on position.
Place the control selector switch in the upper control
position.
3. At the upper controls (refer to Figure 7.19), pull the
emergency stop button outward and place the start
switch in the on position.
4. Hold the engine/emergency power switch in the
emergency power position and step on the platform
foot switch to verify operation of the aerial platform
using the emergency power system.

Horn

The machine may be equipped with an optional horn.
Operate the horn to ensure that it sounds to warn

personnel in the area.

Electrical Power Outlet

Connect a source of 110 Volt AC power to the power-input
connector located inside the rear of the turntable (refer
to Figure 7.20).
Power-Input
Connector
Figure 7.20 – Power-Input Connector
38
Some machines may have an electrical outlet at the
platform, but no power-input connector on the chassis. In
that case, power is supplied by an optional AC generator.
An external power source is not required.
With the engine running, place the machine/generator
control (refer to Figure 7.21) in the generator position to
provide electrical power to the outlet at the platform and
to the outlet on the end of the generator housing.
Figure 7.21 – Upper Controls
Plug an electrical tool into the receptacle at the platform
and at the generator and try to operate the tool to verify
proper operation of the outlet.
The outlet at the platform is equipped with a ground fault
circuit interrupter (GFCI). Use the following procedure to
test the GFCI.
1. Push the test button (refer to Figure 7.22).
Reset Button Reset Button
Test Button Test Button
Figure 7.22 – Electrical Power Outlet
2. Plug an electrical tool into the outlet and verify the
power is off.
If the power was off, push the reset button to

restore power.
Machine/Generator
Switch
AB60J – 0181972